First layers K8400 - Software (Repetier & Cura) - Whadda forum
Por um escritor misterioso
Descrição
Forum. I have a problem printing the first two layers. With a hole within the model, the outline is only printed twice, while the edges are printed 3x for the outline of the entire model. With the next layers, all edges are printed 3x. Another question, the setting so that the nozzle does not go over the finished model so that no wires are pulled over the model. Greetings Auke
Problems printing black PLA filament - Vertex - Issues while
First Layer Quality - Official Raise3D Community
Overhangs first layer – Assembly and first prints troubleshooting
Strange First Layer after update – Assembly and first prints
Just tuned input shaping, the first layer is pretty fast, but
Cura Slicer - Skin Edge Support. Get good top layers over sparse
Supports first layer is not right - UltiMaker Cura - UltiMaker
Calibrating the print settings for K8400 - Cura (OSX) - Vertex
Cura doesn't generate first layer raft for internal support if
3D Scanning & Printing
3D Printing for Beginners: Slicer Software Explained - STEM
First layer and infill issues – Hardware, firmware and software
Cura doesn't generate first layer raft for internal support if
de
por adulto (o preço varia de acordo com o tamanho do grupo)
